Important; Scan Operating Mode - Promax 8 plus Manual Del Usuario Y Operador

INSTRUCTION MANUEL. PROMAX-8+
g) BEEP
This function permits to activate (ON) or deactivate (OFF) the PROMAX-8+
beeper. When it is on, it sounds on pressing any key or when turning the rotary
selector in order to alert the user.
h) LANGUAGE
This field permits to select the language between: ESPAÑOL, FRANÇAIS and
ENGLISH.
The lower line of the screen shows the version of the unit control software
(15.60 in previous figure)
To leave the global configuration menu, just press the key of the operating mode
you wish to accede.

4.2.2 SCAN operating mode

The SCAN operating mode shows, in a single screen, the signal level of all the
active channels in the channel plan by means of a bar-graph. In addition, the exact level
of any particular channel may be measured by simply placing the marker over it (only
analogue channels).
To access to this operating mode,
press the SCAN key [11]. The top line of
the screen will display the channel name
(C44), the tuned frequency (655.25 MHz) and the
level (65 dBµV) of the channel the marker is over.
The marker can be moved by turning the rotary
selector [9].
To change the span (shown
bandwidth), press the rotary selector [9]
(the span field is activated) and then turn
it. The span is variable from the entire
band (full span) to 10 MHz in the following steps:
10, 30, 100, 300 MHz y full span.
May 2001

IMPORTANT

Figure 10.- SCAN mode, full span.
Figure 11.- SCAN mode, span 100 MHz.
Page 19