Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - Hercules DS 405 L Manual De Instrucciones

Anleitung_DS_405_L_SPK7:_
GB
described in Section 5.3.2) and take the panel off
the table.
6.5 Operating the LED light (Fig. 1/5)
Switch the machine on as described in 6.2.
The LED light (7) can now be switched on and off
with the switch (4).
6.6 Operating the laser (Fig. 8/21)
Switch the machine on as described in 6.2.
The laser (21) can now be switched on and off
with the switch (5).
Unlock the saw blade guard (11) as described in
5.3.1. Swing the saw blade guard (11) towards
the back.
The laser line (21) projected onto the workpiece
can now be adjusted using the laser adjusting
screw (22). To do so, undo the laser adjusting
screw (22) and adjust the laser (21) as required.
Then retighten the laser adjusting screw (22)
firmly.
Important! Always use the laser adjusting screw
(22) to adjust the laser line, never the laser itself!
Risk of injury from the moving saw blade.
6.7 Storage of the saw blade (Fig. 6)
Saw blades can be stored in the saw blade
storage compartment (13) whenever they are not
required. To open and close the saw blade
storage compartment (13), please refer to Fig. 6.
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
7.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
12
29.08.2008 14:47 Uhr Seite 12
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
7.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.