Premiere Products HV 13 Instrucciones De Funcionamiento página 3

• Store in a dry place.
• To ensure efficient motor cooling, the air intake around the chrome motor cover should be kept clear of dirt,
dust and fluff using a dry brush.
• Leaving your machine standing on brushes, drive plates or pads when not in use, even for short periods,
will distort and damage the accessories and destabilise the machine in operation.
• Continued use during a voltage reduction will cause overheating and may result in the motor burning out. If
a noticeable drop in voltage supply occurs, it is advisable to switch off and investigate.
• Heeling the machine whilst in operation by raising or lowering the handle excessively in order to increase
the pressure between the brush or pad and the floor, can damage both the machine and the floor covering.
Warning
The plug should not be subjected to undue stress by pulling on the supply cord.
WARNING - The HV 13, HV 15 & HV 17 must be earthed.
E GREEN & YELLOW
N BLUE
L BROWN
Important
The specification chart details which models are available for alternative power supplies i.e. 220v, 110v,
50Hz or 60Hz. Since a different plug and fuse rating may be required it is essential to specify the power
supply when ordering your machine.
6 If the plug fitted to the appliance is not correct for your socket outlets it should be cut off and the correct
plug fitted. DESTROY the removed plug which will be dangerous if plugged into a live socket.
7 For moulded plugs, replacement fuse covers must be the same colour as the one originally supplied.
NEVER use with fuse cover omitted.
Cables and Extension leads
Each machine is designed for use with a specified cable. Similarly the specification and length of any
extension lead is critical to the safe and efficient operation of all Premiere machines. We strongly advise that
only cables and extension leads supplied by Premiere are used.
See Guarantee section on page 8.
Before Use
1 Check that the voltage stamped on the serial plate is the same as
your supply voltage.
2 The wires in the mains lead of these appliances are coloured in
accordance with the following code: Green and yellow : Earth /
Blue : Neutral / Brown : Live.
3 As the colours of the wires in the mains leads of these appliances
may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured green and yellow must be connected
to the terminal in the plug which is marked with the letter E or by
the earth symbol, or coloured green or green/yellow. The wire
which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black. The wire which is
coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.
4 A 230V power supply required the use of a 3-pin fused plug.
5 Fuse rating 13 amp.
3