Motorola MT060 Manual Del Usuario página 8

USING THE LIGHT
There are 5 lighting modes:
• High (100% power)
• Normal (50% power)
• Energy saving (25% power)
• Emergency flash
• SOS
Press once to turn the light ON or OFF.
Press twice quickly, to change to the
next mode.
USING THE AC POWER OUTLETS
The MT060 is equipped with a 500W pure
sine wave inverter, which produces the
best power for all electronic devices and
appliances, without damage.
It is important to know the continuous
wattage of the device you plan to use with
the AC outlets. The unit must be used with
devices drawing 500 watts or less.
Devices such as fans or electric
motors require additional power to start
(commonly known as the "starting" or
"peak" power). The generator can supply
a momentary surge in wattage of as high
as 2,500W for less than 1/10 of a second;
however even devices rated less than
the maximum 500 watts can exceed the
inverter's surge capability and cause an
automatic overload shutdown.
Do not use the inverter with a product that
draws a higher wattage than the inverter
can provide, as this may cause erratic
operation.
CAUTION: Always run a test to establish
whether the inverter will operate a
particular piece of equipment or device.
In the event of a power overload (noted
with an audible alarm beeping every 3
seconds and a flashing
the inverter is designed to automatically
shut down. This safety feature prevents
damaging the inverter while testing devices
and equipment within the 500-watt range.
If powering more than one device, start one
device at a time to avoid a power surge and/
or inverter overload. The surge load of each
device should not exceed the inverter's
Continuous Operation wattage rate.
You can use an extension cord from the
inverter to the device without significantly
decreasing the power being generated by
the inverter. For best operating results, the
extension cord should be 16 AWG (1.31 mm
or larger and no longer than 50 feet.
WARNING! RISK OF ELECTRIC SHOCK.
Incorrect operation of your inverter may
result in damage and personal injury. The
inverter output is 110V AC and can shock
or electrocute the same as any ordinary
household AC wall outlet.
Warning icon),
)
2
• 8 •
NOTE: The maximum continuous load
is 500 watts. Do not use the AC outlets with
a product that draws more than 500 watts,
as this may cause erratic operation.
CAUTION:
• Do not connect an AC power source to
the 110V AC outlets.
• Do not connect the unit's AC power cord
to its 110V AC outlets.
NOTE: Do not power an AC device while
charging the internal battery.
1. Connect your AC-powered devices or
small household appliances to one or
more of the unit's two AC outlets.
NOTE: Make sure the device to be
powered is OFF before inserting the plug
into the AC power outlet.
2. Press the AC Output button. The
AC Output icon will show on the
display and the green AC power LED
lights, to confirm that the unit is on and
ready to provide AC power. The rotating
Discharging indicator will also show
on the display.
NOTE: Extended operation of an AC device
may result in excessive battery drain.
3. Recharge the unit when the battery
level is below 40%.
ESTIMATED RUN-TIMES
APPLIANCE TYPE
Projector
12V Heated blanket
12V Cooler
Mini refrigerator
Drone
Television
Fan
Router
Table lamp
Laptop
LED lights
Go Pro
Radio
Tablet
Speaker
Smartphone
NOTE: Actual time may vary. Times are based
on the internal battery being fully charged.
ESTIMATED
CHARGES
RUN TIME
8 hours —
15 hours —
17 hours —
23 hours
24 hours 145
24 hours —
29 hours —
60 hours —
65 hours —
117 hours 17
167 hours —
210 hours 140
245 hours —
273 hours 22
750 hours 63
843 hours 70