Assembly Of The Mixing Vessel And The Lid; Operation Of The Mixing Attachment - Profi Cook PC-AE 1002 Instrucciones De Servicio

Extracting Juice
NOTE:
The appliance is intended for short-term use.
Allow a pause of 3 minutes after 1 minute of
operation.
WARNING!
Check all accessories again for proper attach-
ment before switching the appliance on.
1. Set the switch to the desired position. The mo-
tor starts running.
2. Insert the fruit pieces in the filler opening and
push them down with the tamper. Please note!
The tamper has a guideway in the filler
opening.
3. The juice flows out at the right side of the cas-
ing. The pulp is collected in the pulp container.
NOTE:
• Observe the juice jug. Stop operation in time
to prevent overflowing.
• Berries and citrus fruits (such as gooseber-
ries, grapes, oranges) are usually not juiced
but pressed.
• When juicing these fruits with their high juice
content, splashing of juice from the area of
the pomace container may occur. In this case,
we recommend that the pomace container is
emptied more frequently.
Stop Operation And Disassembly
1. Set the control knob to "OFF" position and
wait until the centrifugal sieve has come to a
complete standstill.
2. Disconnect from mains power supply.
3. Take the juice jug to the side and open the
safety bracket.
4. Remove the transparent cover.
5. Remove the centrifugal sieve with the centri-
fuge casing. Use both hands to lift the centri-
fuge casing up.
WARNING risk of cuts! The centrifugal
sieve has sharp knives! Only take hold of
the outer plastic edge.
6. Lift the centrifugal sieve out of the centrifuge
casing.
Assembly of the Mixing Vessel
and the Lid (see Fig. B)
1. Hold the mixing vessel so that the handle is on
the right side.
2. Place the mixing vessel onto the device base
so that the symbol at the lower edge of the
vessel points to the symbol of the device
base.
3. The symbols must be directly one above the
other.
4. Set the black lid onto the vessel so that its flap
closes the pouring opening of the mixing ves-
sel.
5. Set the cap of the filling opening into the black
lid.
6. Turn the cap a short distance in clockwise
direction to lock it.

Operation of the Mixing Attachment

CAUTION:
• Always switch off the device before removing
the mixing vessel from the base.
• Always wait until the mixing knife has stopped
turning.
• The glass can crack in case of high tempera-
tures! Do not fill in liquids with a temperature
over 60°C.
• Do not overfill the mixing vessel! You can fill in
a maximum of 1.8 litres. Observe the grada-
tion on the vessel.
• Do not fall short of the quantity of 0.6 litres!
The mixing knifes could run dry and damage
the seal.
• Never fill hard ingredients into the mixing ves-
sel! This is a mixer, not a mincer. Ingredients
like nuts, ice, and coffee beans damage the
device.
45