Sony WRT-805B Manual De Instrucciones página 18

Settings
To change the channel selection
If the channel number is not flashing on the display, press
the SET button so that the channel number flashes.
1
Press the + or – button to select the channel.
Pressing the + button cyclically changes the channel
indication in the order shown in the table of the selected
group in "Sony Wireless Microphone System Frequency
List." Pressing the – button changes it in reversed order.
AF RF BATT
+ button
– button
CH
If you keep either button pressed, the channel number
will be incremented or decremented successively.
Example: when the group 00 is selected for CE62 model
6201 6202
6463
12
(GB)
AF RF BATT
CH
Display example for CE62 model
6263
6302 6301
2
Once the desired channel number appears, set the
POWER switch to OFF to release Setting mode.
Or, press the SET button to continue operations in Setting
mode.
The next time you turn on the power only by setting the
POWER switch to ON, the transmitter will be set to
Transmit mode with the selected channel.
Notes
• The unit cannot transmit in Setting mode.
• Make sure that the channel selected is the same as that
selected on the tuner used in the same system.
• Depending on the noise or interference conditions, the
selectable channels may not necessarily all be usable. If
necessary, you can determine the usable channels by
stepping the channel selection through a number of
channels on a tuner with the transmitter set to OFF. Those
channels on which the RF indicator of the tuner does not
light are usable.
• If there is a TV broadcasting station near by, do not use
the station's channel.
• The unit may not operate correctly if it is turned on again
immediately after turning off the power while in setting
mode. Pause for a few seconds or more before turning on
the power again.