Transport, Packaging And Storage - WIKA CPH62I0-S1 Manual De Instrucciones

5. Transport, packaging and storage

5. Transport, packaging and storage
5.1 Transport
Check hand-held pressure indicator for any damage that may have been caused by
transport. Obvious damage must be reported immediately.
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change
in installation site, sending for repair).
5.3 Storage
Permissible conditions at the place of storage:
Storage temperature: -20 ... +70 °C
■
Humidity: 0 ... 95 % relative humidity (no condensation)
■
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Store the hand-held pressure indicator in its original packaging in a location that fulfils
the conditions listed above. If the original packaging is not available, pack and store the
hand-held pressure indicator as described below:
1. Wrap the hand-held pressure indicator in an antistatic plastic film.
2. Place the hand-held pressure indicator, along with shock-absorbent material, in the
packaging.
3. If stored for a prolonged period of time (more than 30 days), place a bag, containing a
desiccant, inside the packaging.
WARNING!
Before storing the hand-held pressure indicator (following operation),
remove any residual media. This is of particular importance if the
medium is hazardous to health, e.g. caustic, toxic, carcinogenic, radioac-
tive, etc.
WIKA operating instructions, model CPH62I0
GB
17