RAWLINK 79587 Manual De Instrucciones página 24

bl bl
Fit the foot pedal (10) to the shaft of the
pump.
Remove the 2 pieces of wood the
motorcycle hoist is resting on.
1 1
bo bo
Fit the wheel clamp (2) to the lift table (3)
using bolts, washers and nuts.
Fit the clamping brackets (13) to the lift
table using nuts.
Fit the stop plate (1) at the front of the lift
table using bolts, washers and nuts.
24
2 2
bo bo
Use
Place the motorcycle hoist on a hard,
horizontal surface and adjust the support
feet (12) so that the hoist is stable.
Lower the lift table (3) to its lowest position
by pressing the release pedal (9).
Drive the motorcycle up onto the lift table
via the ramp (5). Flip the kickstand down and
tighten the front wheel securely to the wheel
clamp (2).
Tighten the motorcycle securely to the
clamping brackets using suitable straps so
that it cannot tip over.
Remove the ramp, if appropriate. Lift the lift
table up fully using the foot pedal (10) until
the lift table will not go any higher.
Insert the safety bolt (11) into the desired
holes on the support (6) and press the
release pedal. The lift table will drop until it
rests on the safety bolt.
Remove the removable plate (4) if required
to facilitate access to the underside of the
motorcycle hoist.
Lower the lift table by � rst raising it to the
maximum height using the foot pedal, and
then removing the safety bolt. Check there
is nothing under the lift table and lower it to
the lowest position by pressing the release
pedal. Replace the ramp if detached, and roll
the motorcycle off the lift table.
Never allow the lift table to lower too fast!