GE 20 Serie Manual Del Propieratio página 25

Installation instructions
[] REMOVE THE CENTER HINGE PIN
[] On models with a freezer door, tape the
door shut with masking tape.
[] Using an adjustable wrench, remove the
center hinge pin.
[]
[]
REMOVE THE FREEZER DOOR
(freezer door models)
Remove the tape and tilt the door away
from the cabinet. Lift the door off the
bottom hinge pin.
NOTE: There is a plastic washer between
the hinge and the top of the freezer door.
Do not lose.
[] Set the door on a non-scratching surface
with the inside up.
[] TRANSFER BOTTOM HINGE
BRACKET (freezer door models)
[] Remove the base grille by grasping it at
the bottom and pulling it straight out.
[] Using a 3/8" or 10 mm socket
ratchet/driver, remove the screws
securing the bottom hinge bracket to the
cabinet.
[] Using an adjustable wrench, remove the
hinge pin and washer(s) from the right
side of the bracket and install on the left.
_'-_"_- J Washer(s)
[] REMOVE CENTER HINGE
Using a 3/8" or 10 mm socket
ratchet/driver and Phillips head
screwdriver, remove the bolts and screws
securing the center hinge to the cabinet.
Set hinge, bolts, screws, washer (on
freezer door models) and hinge pin aside.
On models with a freezer drawer, skip to
Step 7.
25