Profi Cook PC-ES 1008 Instrucciones De Servicio página 61

WARNING: Danger of scalding!
Escaping steam can cause injuries. During the
heating process hot steam/water can escape
from group head and/or steam nozzle!
• Ensure that the steam control knob (4) is set
to " " position before activating the steam
function.
• Do not direct the steam nozzle towards
persons.
• Always place a container under the steam
nozzle (6).
1. Ensure that push button (11) is in STANDBY
position.
2. Swivel out the steam nozzle (6). Ensure that
the steam pipe is properly attached. Attach the
steam nozzle cover all the way on the steam
nozzle.
3. Place a heat-resistant container under the
steam nozzle.
4. Fill the jug half with cold milk.
5. Press push button (12) to STEAM Position.
Wait until the indicator lamp
6. Briefly open the steam control knob (4) to-
wards " " every time before using the frothing
function to drain collected condensate. The ap-
pliance is ready to use if only steam escapes.
7. Place your milk jug with the milk under the
steam nozzle.
8. Lift the jug so that the steam nozzle sits just
under the milk surface.
NOTE:
Do not place the steam nozzle in the centre
of the jug but close to the inner wall. This
position is important for the milk to get into
whirling motion. We recommend using the
spout as guide for the steam nozzle.
9. Slowly open the steam control knob (4) to-
wards " " until the desired amount of steam is
set. Slightly move the jug up and down. Close
the steam control knob towards " " after the
milk has frothed to the desired volume
(approx. 50%).
NOTE:
• To further heat up the milk insert the
steam nozzle all the way to the bottom of
the jug. Ensure that the milk does not start
boiling. In this case the foam will collapse.
• The water is no longer hot enough if the
indicator lamp (14) turns off during froth-
ing. Turn the steam control knob towards
" ". Wait until the indicator lamp
lights up again. Now continue frothing the
milk.
10. To remove the last coarse air bubbles knock
the milk jug after frothing carefully on the
tabletop (as if you would set it down a bit hard).
Swivel the milk jug slightly around. This helps
to mix the foam after frothing. Now waste no
time. Pour the frothed milk slowly into the
espresso.
11. Swivel the milk jug slightly around while pour-
ing the frothed milk slowly into the espresso.
NOTE:
lights up.
• With a few artful movements you can
draw designs into the foam.
• Sprinkle cocoa powder or cinnamon to
taste on the foam.
12. IMPORTANT: Clean the steam nozzle im-
mediately after every use! When closing
the steam control knob a vacuum is created
within seconds, which draws some milk into
the steam nozzle. Place your heat-resistant
container under the steam nozzle. Open the
steam control knob briefly for a shot of steam
to flush milk residue out of the steam nozzle.
Wipe the steam nozzle with a damp cloth.
13. Press push button (12) to ESPRESSO position
to turn the steam function off.
14. To stop operation switch the appliance off.
Push button (10) is in OFF position.
61