Control Elements; Installing The Transmitter - Dometic VT100WiFi Instrucciones De Montaje

Installing the transmitter

5.2

Control elements

No. in fig. 1, page 3
1
2
3
4
5
6
6 Installing the transmitter
Tools required (fig. 3, page 4)
6.1
For installation and assembly, you will need the following tools:
• Drill head set (1)
• Drill (2)
• Screwdriver (3)
• Set of ring or open-ended spanners (4)
• Measuring ruler (5)
• Hammer (6)
• Centre punch (7)
To establish and test the electrical connection, the following tools are required:
• Diode test lamp (8) or voltmeter (9)
• Crimping tool (10)
• Insulating tape (11)
• Cable bushing sleeves (optional)
To secure the transmitter and the cable, you may require additional screws and cable binders.
10
Meaning
Antenna connection
Operating display; lights up as soon as voltage is applied
Camera connection
Green cable (REVERSE TRIGGER):
Control cable
•
for activating the camera
•
for activating the motor shutter of the CAM80CM; only
effective if the transmitter is connected to the ignition plus
Red cable (DC INPUT): Connection to the positive terminal (+) of
the power supply; preferably ignition plus
Black cable (GND): Connection to the negative terminal (–) of the
power supply or earth terminal
VT100WiFi
EN