COFAN 09000121 Manual De Instrucciones página 19

17
3. Information of Temperatures.
(1)The temperatures at the handle (8 hours/Operation) is 30º C.
4. Warnings.
(1) The power tools shall not be used in explosive atmospheres unless specially designed for that
purpose.
(2) Unexpected tool movement due to reaction forces or breakage of inserted tool or reaction bar
may cause injuries to hands or feet.
(3) The power tools shall be isolated from the energy source before changing or adjusting the
inserted tool.
(4) Pay attention to the risk of crushing by torque between a reaction bar and the work piece.
(5) Pay attention to the risk of loose clothing, hair etc. being caught in the rotating spindle of the
power assembly tool.
(6) Pay attention to the risk of being injured if hands are not kept away from the reaction bar, spe-
cially observed when unscrewing in confined work places.
(7) Pay attention to the risk of being injured if hands are not kept away from the nut runner sockets.
(8) Pay attention to the danger to persons from high speed splinters being emitted in the case of a
nut-runner socket failure, in particular relevant of impact wrenches.
(9) Pay attention to the risk of being injured by whipping air hoses.
5. Instructions.
(1) On the proper adaptation of the reaction bar to the application.
(2) Use only sockets and adapters which are in good condition and are intended for use with power
tools.
(3) Ensure that the assembly power tool is securely fixed to suspension advice, if used.
(4) Adopt a suitable postures to counteract normal or unexpected movement of the power tool due
to reaction forces from the power assembly tool.
(5) Ensure that the pressure of the air or fluid supply is not lower than the lowest pressure specified
by the manufacturer for clutch controlled assembly tools and make sure that the air or fluid supply
pressure does not fail after the clutch has been set.
(6) Release the start and stop device in the case of an interruption of the energy supply.
(7) Only lubricants recommended by the manufacturer shall be used.
ENGLISH