Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
To remove the sanding sheet 10, grasp it at one of the tips
and pull it off from the sanding plate 10.
Selecting the Sanding Sheet
Depending on the material to be worked and the required
rate of material removal, different sanding sheets are
available:
Sanding disc
Red quality
Dust/Chip Extraction
l Dusts from materials such as lead-containing coatings,
some wood types, minerals and metal can be harmful
to one's health. Touching or breathing-in the dusts can
cause allergic reactions and/or lead to respiratory
infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in connection
with wood-treatment additives (chromate, wood
preservative). Materials containing asbestos may only
be worked by specialists.
– As far as possible, use a dust extraction system
suitable for the material.
– Provide for good ventilation of the working place.
– It is recommended to wear a P2 filterclass respirator.
Observe the relevant regulations in your country for the
materials to be worked.
Connecting the Dust Extraction (see figure A)
For sanding, always connect dust extraction.
Remove the application tool/accessory when mounting the
dust extraction 11 (accessory).
If required, assemble the parts of the dust extraction 11 as
shown in the figure. Position the assembled dust extraction
onto the machine via the tool holder 4.
Depending on machine version, place a vacuum hose
(accessory) either directly onto the vacuum connection 12.
Connect the vacuum hose with a vacuum cleaner
(accessory). An overview for the connection of various
vacuum cleaners can be found on the fold-out page.
The vacuum cleaner must be suitable for the material being
worked.
When vacuuming dry dust that is especially detrimental to
Material
- All wooden
materials (e.g.,
hardwood, softwood,
chipboard, building
board)
- Metal materials
ENGLISH
13
Application
For coarse-sanding, e.g. of rough,
unplaned beams and boards
For face sanding and planing small
irregularities
For finish and fine sanding of wood
health or carcinogenic, use a special vacuum cleaner.
4. Operation
l Observe correct mains voltage! The voltage of the
power source must agree with the voltage specified
on the nameplate of the machine. Power tools
marked with 230 V can also be operated with 220 V.
Starting Operation
Switching On and Off
To start the machine, push the On/Off switch 1 forward so
that the "I" is indicated on the switch.
To switch off the machine, push the On/Off switch 1 toward
the rear so that the "0" is indicated on the switch.
Preselecting the Orbital Stroke Rate
With the thumbwheel for preselection of the orbital stroke
rate 2, you can preselect the required orbital stroke rate,
even during operation.
The required stroke rate depends on the material and the
working conditions and can be determined through
practical testing.
Working Advice
Note: Do not cover off the venting slots 3 of the machine
while working, as this reduces the working life of the
machine.
13
Grain size
coarse
60
medium
80
fine
210
Publicidad
Tabla de contenido
