Set-Up And Operation - EUROM VK2002 Manual De Instrucciones

20. Close supervision is necessary when the product is used near children or incapacitated persons. Do not let
children use the appliance as a toy. This appliance is not suitable to be operated by children or persons who
have physical, sensory and/or mental limitations, or by persons who have no knowledge of, or experience
with, this appliance.
21. Keep the heater clean. Dust, dirt and/or a build up of deposits in the heater are a common cause of
overheating. Make sure these deposits are removed regularly.
22. Do not turn on the appliance if you have discovered damage to the appliance, cord or plug, if the appliance is
malfunctioning, if it has been dropped or if there are signs of any other defect. Return the complete product to
the vendor or to a certified electrician for inspection and/or repair. Always ask for original parts.
23. Do not use attachments and/or accessories, not recommended or supplied by the manufacturer.
24. The appliance (incl. cord and plug) may only be opened and/or repaired by properly authorised and qualified
persons.
25. Only use this heater for its intended purpose and as described in this instruction manual.
Not abiding by instructions 23, 24 and 25 may lead to damage, fire and/or personal injuries. A failure to adhere to
these rules also immediately nullifies the guarantee and vendor, importer and/or manufacturer do not take
responsibility for any of the consequences!
Description
VK2002
Location and Connection

Remove all packaging material and keep out of reach of children. After removing packaging, check the
appliance for damage or other signs that could indicate a fault/defect/malfunction. In case of doubt, do not
use the appliance, but contact your vendor for inspection or replacement.

Choose a suitable location for the heater which is at least one metre away from any obstructions, walls or
inflammable materials (see also safety instructions).

Make sure a functioning heater is always placed on a solid, flat and horizontal surface.

Check if the control dial is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 230V socket. To prevent the circuit overloading, check
that no other appliances are connected to the same group.

Set-up and Operation


Turn the thermostat dial to maximum (clockwise as far as possible).

Switch the heater on by turning the control dial to one of the following three positions:
(VK2002)
I
Heating at half power (1000W)
II
Heating at full power (2000W)
The light at the front will turn on.
Ultrafan
(Ultrafan) Fan only (thermostat always to maximum)
12
1 – control dial
2 – thermostat dial
3 – pilot light
4 – handle
(Ultrafan: reverse side)
5 – air outlet grill
6 – air intake grill (reverse side)
7 – oscillating function switch
(Ultrafan only)
8 – oscillating foot (Ultrafan only)