SCANGRIP CANVIK BASIC Instrucciones De Uso página 5

Protective vice jaw for clamping spring compressor
Operation Advice

Remove the McPherson spring strut.

Select jaws according to table (page 32-46) and mount on the
spring compressor. Fit the retaining bolts and tighten firmly.
It is very important for your safety that the bolts of the jaws
are firmly tightened.

Rotate the drive nut to drive the jaws apart to match the length of
the spring and to compress as many windings as possible.

Place the coil spring compressor in a suitable vice.

Place the spring strut onto the coil spring compressor. Take care
that the seating of the spring windings in the jaws is correct.

With an impact wrench or a racket spanner, turn the drive nut until
the upper support bearing is free. Additional compressing is permit-
ted.
When using impact wrench do not exceed 180Nm
torque limit.
90.1020