Operating Instructions - Marmitek POWERMID XL Instrucciones De Uso

OPERATING INSTRUCTIONS

1. Plug the POWERMID XL Transmitter into a 220V/240V outlet in the room where you
want to use your remote control (up to 20 feet/6 meters away from where you
normally sit). Make sure the front of the unit (with POWERMID name) is facing you.
Fully extend the antenna.
2. Plug the POWERMID XL Receiver into a 220V/240V outlet in the room where your
TV, VCR, Stereo, etc. is located (up to 20 feet/6 meters from it). Point the front of
the Receiver towards the TV, VCR, stereo etc. Fully extend the antenna.
3. Point your remote control at the POWERMID XL Transmitter. It receives the signals
and transmits them to the POWERMID XL Receiver. The POWERMID XL Receiver then
re-transmits these infrared signals to your TV, VCR, stereo, etc.
Add more Transmitters to use your remote controls in several r-ooms.
Add more Receivers to control equipment in different rooms.
Add an Infrared Extender (sold separately) if you need to place the POWERMID XL
Receiver next to your equipment instead of in front of it, or if your equipment is
located inside a closed cabinet.
Note: The Transmitter and Receiver will most likely be in different rooms
(up to 100 feet/30 meters away). The range is depending on:
1. The number of floors and walls the signal has to travel through and material these
walls and floors are made of.
2. Other 433MHz sources (e.g. wireless head phones, wireless speakers) can effect the
range of the PowerMid XL. The best range will be achieved when these sources are
switched off while using the PowerMid XL. Cordless phones will not affect the
PowerMid XL.
3. Some satellite receivers require more careful positioning of the Powermid system. If
any difficulty is encountered, try to move the Powermid (Receiver) a little to various
positions until it operates correctly.
POWERMID XL 3