Ornytion 207P Manual De Usuario página 10

The wiring process will be as follows:
Unscrew the connector (green part) from the accessory.
•
Pass the cable end through the bottom of the accessory and put it through the rubber
•
grommet.
Remove the cable sleeve and mesh, leaving about 20 mm of internal wires exposed. Peel
•
the wires from 5 to 7 mm.
Solder the wires onto the pins inside the connector
•
Screw the connector by turning the bracket and maintaining the connector upright (the
•
wind vane can be used as a wrench to slightly tighten the screw).
Tighten the plastic screw to secure the wire.
•
Then proceed to fit the accessory in the support tube:
Pass the cable through the tube.
•
Insert the tube into the bottom of the accessory until it stops.
•
Slightly tighten the two attachment screws with a 3mm Allen
wrench (not included).
Place the bracket in its location with the accessory in a vertical
•
position.
Align the attachment so that the notch on the connector points
•
north. Tighten the two Allen head screws to secure the base to
the tube.
Wind Vane
Put the connector of the wind vane above the fastening accessory so
that the notches are aligned.
Turn the wind vane slightly counterclockwise to clockwise until it
snaps into place.
Holding the body of the wind vane in one hand, tighten the connector
by turning the screw counterclockwise (viewed from above) until you
hear a click.
Check that the wind vane is vertical and correctly orientated. If
necessary adjust the support to achieve this.
To unscrew the wind vane, hold the body and with slight downward
pressure and turn the screw clockwise (viewed from above)
10