Speck BADUJET Primavera Instrucciones Para El Manejo página 88

Installation
Mounting the main housing in a foil, polyester, steel or
aluminium pool (A)
NOTICE
Only tighten the screws hand-tight. Do not use any force!
1. Position the top outlet connection (B) above the inlet
connection (C).
2. Installation depth: The middle of the main housing/nozzles
should be mounted 30 cm under the water level.
3. Drill holes using the enclosed drilling template.
4. Cut out the housing opening in the pool wall.
5. Insert the nub seal (26) in the housing (1).
6. Align the housing (1), place it onto the outer pool wall and
fasten it to the pool wall (without film) using the two tapping
screws (103).
7. Lay the support ring seal (27) under the handle (70) from the
pool inside.
8. The pool wall is clamped between the support ring (28) and
the main housing (1) with the tapping screws (52).
9. The dummy plate (30), with the four tapping screws (103), is
used to protect the housing during plastering and as a cover
in the case of commissioning the swimming pool without the
final assembly kit being installed.
Please observe the installation sketch.

26 EN 01|2018