Mounting The Main Housing In A Polyester, Steel Or Aluminium Pool - Speck BADU Jet primavera Manual De Uso

5 Installation
Mounting the main housing in a tiled concrete pool
Please observe 5.3.3: Aligning the support ring
34 106
In a tiled pool the tile thickness is compensated for with an additional
support ring (28) and longer tapping screws (52). The parts are
available optionally in the additional kit.
5.2.2

Mounting the main housing in a polyester, steel or aluminium pool

Ensure that the top outlet connection is positioned above the inlet
connection. Determining the mounting depth: The middle of the main
housing / nozzles should lie 30 cm under the water level. Drill holes
using the enclosed drilling template. Cut out the housing opening in the
pool wall. Insert the nub seal (26) in the housing (1), align the housing
(1) and place it against the pool wall from the rear. The support ring
seal (27) is laid under the handle (70) from the pool inside. The pool
wall is braced together between the support ring (28) and the main
housing (1) with the tapping screws (52). The dummy plate (30) is used
in those cases where the swimming pool is commissioned without the
final assembly kit being installed. ATTENTION: Do not over-tighten the
screws!
64 EN VG 766.2320.050
1
105
1
103
30
28
26
70
28
52
Fig. 4
12/2014