Wagan Tech Solar e Power Case 450 Manual De Usuario página 13

Plug DC Charging Adapter into vehicle DC accessory socket
To charge the Solar e Power Case using the DC Charging Adapter:
only uSe The dC Charging adaPTer SuPPlied wiTh ThiS uniT. do noT ConTinuouSly Charge For more Than
16 hourS uSing The dC To dC meThod.
1. Note that the engine must be running while charging the Solar e Power Case to avoid
discharging the vehicle's battery.
2. Make sure all Solar e Power Case switches are set to OFF.
3. Plug the DC Charging Adapter into the Solar e Power Case's DC Outlet.
4. Plug the other end of the DC Charging Adapter into the vehicle's accessory socket
(cigarette lighter socket).
5. Periodically remove one DC plug and check the Digital LED Voltmeter to determine
when charging is complete (usually 13.5V is considered fully charged)
6. After charging the battery, disconnect the DC Charging Adapter from the vehicle acces-
sory socket first, then from the Solar e Power Case DC Outlet.
7. Store the DC Charging Adapter in the Storage Hatch.
Do not leave the Solar e Power Case connected to your vehicle's DC socket when the engine is
turned off.
CauTion—equiPmenT damage:
• While the Solar e Power Case is being charged with the DC Charging Adapter from
your vehicle, do not operate the Inverter with a load of over 100 watts. Further, do not
plug in or operate any DC appliance from the Solar e Power Case that requires more
than 10 amps. Either action may blow a vehicle fuse.
• Always remove the DC Charging Adapter from the vehicle's DC socket before starting
the vehicle.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation
User's Manual—Read before using this equipment
© 2011 Wagan Corporation
All Rights Reserved
13