Publicidad
Idiomas disponibles
Idiomas disponibles
l
. CAuTioN
..................
When
you remove
the end caps, a
small metal washer
on each end
may come
off.DO NOT
lose these
two metal washers.
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning
efficiency
high and to prevent damage to your vacu-
um, the agitator must be cleaned every time
the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Use
HEAVY
-
(used daily)
MODERATE
-
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
Clean Agitator
every week
every month
every 2 months
Remove
any dirt or debris
in the belt path
area or in the brush
roller area.
Carefully
remove any string or debris
located
on the agitator,
end caps, wash-
ers or agitator shall
IMPORTANT
Replace
the
washers
and
the end caps.
See the explod-
ed view for cor-
rect
assembly,
Disconnect
cleaner from electrical
outlet.
Check and remove hair, string and lint build-
up frequently
in the Power-Mate ® agitator
and end cap areas. If build-up becomes
®
excessive,
disconnect
Power-Mate
from
wand and follow the steps below_
TO
REMOVE BELT
1, Turn Power-
Mate _ upside
down,
2. Unscrew the
two (2) Power-
Mate ® cover
screws,
3. PJrn Power-
Mate ® right side
up. Press handle
release pedal and
lower the swivel.
Lift rear latches up_
4, To remove cover,
grasp the sides and
pull out.
5. Depress
tabs on rear of
agitator cover
and rotate
forward to
release from
the Power-Mate ® base.
Agitator
Cover
Tabs
End Cap
check and clean
end cap areas. See
AGITATOR
ASSEMBLY
for
picture of complete
agitator assembly,
6. Lift agitator
assembly out
and remove
worn belto
7. Slide end
caps off to
End Cap
/
'!7
Publicidad
