Safety Instructions - Ricatech PR390 Manual De Usuario

Read the User Guide carefully before use!
Save these instructions for future reference.
1. Follow all warnings on the product and in the User Guide.
2. Unplug the power cord before cleaning. Do not use liquid detergents or aerosols.
Use a soft cloth to clean.
3. Only use accessories and optional equipment recommended by the manufacturer in order to avoid
unnecessary risks.
4. Do not use the product near water, such as a bath, washbasin, washbowl, kitchen sink, in a wet
basement or near a swimming pool.
5. Do not place the product on an unstable surface. It may fall, causing serious
personal injury or damage to property. Only use with the carriage, stand,
bracket or table supplied, or as recommended by the manufacturer.
The manufacturer's instructions must be followed during all assembly and
only assembly accessories recommended by the manufacturer may be used.
6. Ventilation openings in the cabinet are provided for the product to work correctly
and not overheat.
The openings must not be blocked or covered. Do not place the product on a bed, sofa, carpet or
the like so that the openings can be blocked. Adequate ventilation must be provided if the product
is built into e.g. a bookshelf or stand and the manufacturer's instructions must be followed.
7. Check that the mains voltage corresponds to the rated voltage on the type plate. For products
designed for use with a battery or other power source there is more information in the User Guide.
8. Place the power cord so that it cannot be stood on or clenched.
9. The product is equipped with a fuse protected plug with overload protection. This is a safety device.
The User Guide contains information regarding the replacement and resetting of the safety device.
If the plug must be changed, the service technician must use a replacement plug recommended
by the manufacturer with the same overload protection as the original plug.
10. Unplug the power cord, wire antenna and any other cables during thunderstorms or storage – risk
of damage to property.
11. The antenna system outdoors must not be positioned close to power lines or other electrical lights
or power circuits. The antenna can fall down on or come into contact with such power lines or
circuits, which are associated with fatal injury.
12. Do not overload wall outlets, extension cords, or built-in power outlets - risk of fire or electric
shock. Do not expose the product to water or any other liquid.
13. Do not try to open the casing – risk of electric shock. Service must only be carried out by qualified
personnel.
14. Once the service or repair of the product has been completed, the service technician must perform
safety checks to determine that the product is working properly.
15. The product must not be placed near heat sources such as radiators, heaters, fireplaces, stoves
and other products (including amplifiers) that produce heat.
16. If the appliance is turned off by unplugging the power cord the plug must be easily accessible.
WARNING!
Do not expose the appliance to rain or damp conditions – risk of electric shock. Do not remove the
casing. The status lamps are soldered. No components can be repaired by the user. Service work
should be carried out by qualified service personnel only.
English

SAFETY INSTRUCTIONS