Putting Into Operation - Venta Kuubel XL-T Manual Del Usuario

PUTTING INTO OPERATION

01 10
Attention!
Make sure that the appliance is switched off and the power cord is
disconnected.
01 Unpack the appliance and set it up. Open the fragrance/filter compartment
7, remove the pre-filter 9, remove and unpack the VENTAcel filter 10.
Re-insert the VENTAcel filter 10 and pre-filter 9.
02
Inserting the fragrance: Twist open the fragrance cap and insert it
03
into the fragrance holder 8. Insert up to three fragrances into the
fragrance holder 8.
Close the fragrance/filter compartment 7.
04
Open the evaporator compartment 3 and remove the water tank 4.
05
Open the water tank 4 and fill up to the MAX marker with water.
06
Close the water tank 4 securely.
07
Insert the water tank 4 into the water basin 6 and close the evaporator
08
compartment 3.
09 The display 1 can be adjusted to three positions.
10 The power cable can be adjusted to the desired length by winding it up in
the cable compartment 11.
Move the appliance with the transportation wheels 14 to the desired place.
Lift the appliance slightly on the right sight.
Attention! The coupling of the mains cable must be plugged firmly into the device!
Please remove the protective foil for battery and
remote control of the remote control.
Connect the power plug and switch on the
appliance at the on/off switch 2 or with the
remote control 13.
ATTENTION! It may take about a minute for the
device to start and for the "Fill Tank" indicator in red or yellow to be extinguished.
A gurgling sound may be heard, but this does not represent a quality defect.
7 US
ON/OFF
Set fan stage