Gima WIDA Manual De Uso página 6

UNPACKING
Always remember that packing elements (paper, cellophane, stitches, adhesive tape,
etc.) can cut and/or hurt if they are not carefully handled.
They shall be removed with adequate means and shall not be left at the mercy of irresponsible
persons; the same is valid for tools used to remove packages (scissors, knives, etc.).
After opening the packages, first of all it is necessary to check all pieces and parts composing
the product. Check that they are all present and in perfect conditions.
INSTALLATION
Before using the product, it is possible to adjust the helmet housing the lamp Wida to the head
size. To do this, make use of the apposite adjusting screws, located on the back and/or on the
top (see picture) allowing tightening or loosening the headbands.
In case several spotlights are available, it is necessary to choose the most suitable optical-fibre
cable terminal (adapter). It is sufficient to screw it in the apposite seat at the cable end.
FUNCTIONING
Once the lamp Wida has been firmly positioned on your head, to turn it on it is sufficient to insert
the cable terminal into the socket of the source of light and turn it on. Then, it is possible to adjust
the intensity of light according to your requirements.
It is also possible to direct the light beam by lifting and lowering the lighting unit. Once the most
suitable position has been found, fix the unit by means of the apposite lock nut (see picture).
As already mentioned, it is possible to adjust the diameter of the light beam of the examination
lamp Wida.
Clockwise rotate the headlight ring to reduce the diameter of the light beam and counter-clockwise
rotate it to widen the diameter.
MAINTENANCE
Before the use, it is advisable to check that the optical-fibre is not damaged. In case it is damaged,
remove and replace it. To this purpose, proceed as follows:
- Open all the automatic snap fasteners on the helmet and release the cable
- Unscrew the lock nut on the front and withdraw the lighting unit
- Clockwise rotate the fastening joint (cod. 30850)
- Counter-clockwise unscrew the lighting unit from the cable, until it can be drawn out
- Insert the new cable and screw it in the lighting unit
- Counter-clockwise turn the fastening joint to replace it in the original position (cod. 30850)
- Reassemble the fastening joint and tighten the lock nut
- Lock the optical-fibre cable by means of the apposite snap fasteners
The examination lamp Wida, cable included, can be cold cleaned with disinfectants and a sponge.
Periodically clean the cable end to avoid dirt deposits.
Disposal: The product must not be disposed of along with other domestic waste.
The users must dispose of this equipment by bringing it to a specific recycling point
for electric and electronic equipment.
For further information on recycling points contact the local authorities, the local
recycling center or the shop where the product was purchased. If the equipment is
not disposed of correctly, fines or penalties may be applied in accordance with the
national legislation and regulations.
ENGLISH
6