Ibiza sound DJM150BT-VHF Manual De Usuario página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
BLUETOOTH PAIRING PROCEDURE
Set the selector switch of channel 1 to BT (center position). Set your Bluetooth device (e.g. mobile phone) to
Bluetooth connection mode. Switch the mixer on. The BLUETOOTH LED will flash slowly. Select "BLUETOOTH"
among the found devices on your mobile phone. You can now play music via CHANNEL1 of the mixer.
WIRELESS MICROPHONE
• Open the battery compartment on the microphone via a screwdriver. Insert a 1.5V battery (included) with the
correct polarity into the battery compartment. Close the battery compartment and tighten the screws.
• Slide the switch ("ON/OFF") upwards to the ON position, the LED below the switch should light and the LED on
the main unit should also light to indicate that carrier signals are being received.
• If the "LOW – BATT" LED on the microphone lights, change the battery.
• Avoid "feedback" (howling or screaming sound through the speaker) by keeping the microphone at a sensible
distance from the speaker and pointing it away from the speaker so that it doesn't hear its own output.
• When not in use, switch the wireless microphone off. If you will not use the microphone for an extended period
of time, remove the battery.
SPECIFICATIONS
INPUTS:
Microphone ........................................................................................................................... 3mV / 2.2 kΩ
Line ..................................................................................................................................... 150mV / 47 kΩ
OUTPUTS:
Main .................................................................................................................................. 0 dB / 1V 600Ω
MON .................................................................................................................................. 0 dB / 1V 600Ω
PHONE ..................................................................................................................................... 300mW/16-32 Ω
Tone Control
Treble.....................................................................................................................................+12dB/-12dB
Middle ...................................................................................................................................+12dB/-12dB
Bass .......................................................................................................................................+12dB/-12dB
GENERAL:
Frequency response ..................................................................................................... 20Hz∼20 kHz ±2dB
Distortion ....................................................................................................................................... <0.02%
S/N Ratio ....................................................................................................................... better than 70 dB
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local authorities
or your dealer about the way to proceed.
©Copyright LOTRONIC 2016
DJM150BT-VHF
6

Publicidad

Tabla de contenido
loading

Tabla de contenido