Display Screen; System Configuration - PNI PG2710 Manual De Usuario

EN
Press key for emergency alarm. This is used only in case of a real emergency in order to alert people
around, and configured phone numbers.

2.3. Display screen

The screen shows:
"SF" when system is armed
"BF" when system is stay armed
"CF" when system is disarmed
"99" when system is in alarm mode
"F1" if phone line is disconected
"F2" if interference alarm is triggered

3. SYSTEM CONFIGURATION

3.1. Connecting system
Connect the alarm system to the telephone line (if available), plug AC power adapter and activate the
battery by On / Off switch. Connect the siren. The system will give a short beep and a voice message, when
initialization is succeeded.
All settings must be done in "Disarm" state.
All configuration operations that will be correctly executed will receive a long confirmation sound, and
wrong or unsuccessful operations will receive two short beeps.
Note: The system comes with included accessories paired from factory: motion sensor, magnetic contact
and remote controls. Check functionality of sensors, and if their trigger is displayed with a zone number on
the screen. Adding accessories is only recommended for additional sensors or in case of malfunction.
3.2. Add/Remove remote control
Add:
*0* Enter * 0 * command from system keyboard, system enters remote control learning mode and
a 10-second countdown starts. Trigger / Press a key on the remote control to register with system. If
successfull, system confirms operation with a long sound.
Delete:
*02* This operation will delete all remote controls registerd in the host.
3.3. Add/Delete detector
Add:
*01* Enter *01* command, system enters detector pairing mode and starts a 10 seconds countdown when
you have to trigger detector , in order to be registerd. If successfull, system confirms operation with a long
sound.
Delete:
#8996# This operation will delete all detectors registerd in the system.
3.4. Add/Delete phone number
Add:
# + [1~6] + [Phone No.] + # Example: To set phone number 0700123456 to position 1, type command:
# 10700123456 #. The system will confirm by repeating phone number on position 1 with voice message.
[1 ~ 6] represents the 6 positions where phone numbers can be stored.
If you want to replace a phone number, enter the command for desired position with desired phone number.
Delete:
# + [1~6] + # Entering this command from keyboard will delete the phone number from selected position.
Ex: Command # 1 # will delete the phone number on position 1.
3.5. Alarm delay
# + [7] + [0~99] + #
When alarm is triggered, the system should respond immediately and siren sound. Alarm delay can set the
4