Anti-Blocking Function (Abs); Cleaning And Care - Lervia KH 4412 Instrucciones De Uso

11. Anti-Blocking
Function (ABS)
At the start of the lamination process, the pouch may
be pulled in at an angle or jam itself inside the appli-
ance.
Slide the Anti-Blocking switch (ABS)
position ABS.
• The laminate pouch is not pulled any further in.
Remove the laminate pouch.
Slide the Anti-Blocking switch (ABS)
the desired foil thickness.
Re-start the lamination process.

12. Cleaning and care

Life-threatening risk of electrical shock:
• NEVER open the housing. There are no
user-serviceable components inside.
• NEVER immerse the appliance compo-
nents into water or other liquids!
Cleaning the housing:
Clean the surface of the housing with
a slightly noistened dish cloth.
First remove the power plug.
Allow the appliance to cool down completely.
Ensure that no moisture can permeate into the
appliance.
Cleaning the interior of the appliance:
With every lamination, contaminants are deposited
on the rollers inside the laminator. Over time, this re-
duces the performance of the laminator. You should
therefore clean the rollers inside the laminator after
use.
i
to the
Prepare the appliance as described in chapter
8 "Preparing for hot lamination", up to the point
where the green LED indicator lamp "Ready"
i
back to
Then run a sheet of DIN A4 paper folded in the
middle (maximum thickness 1.0 mm) ...
• without a laminating pouch and
• with the fold first
... slowly into the slot for manual pouch input
Release the sheet as soon as you notice it being
pulled in automatically.
• The contaminants on the rollers inside the laminator
are now transferred to this sheet of paper. The
paper is ejected from the pouch ejector slot
of the laminator.
Repeat this cleaning process several times.
Use a fresh clean sheet of paper each time.
When you no longer see any contaminants on
the paper, the rollers inside the laminator are
clean.
- 25 -
y
glows.
o
.
u