This Must Be Considered During Installation - Weka Holzbau 594.4070.00 Serie Instrucciones De Montaje

require foundations for reinforcement supports (see section 6 'Installation instructions'). Its creation is
integrated into the general course of events.
Once the ground has been successfully adjusted/levelled, the height and horizontal position of the
foundations are to be marked out.

5.4.2. This must be considered during installation!

•
Swimming pool installation
Note: Always check that the pool is absolutely horizontal.
If the measured values deviate from each other by more than 1.0 cm, the substrate was incorrectly
prepared.
•
Installation of the swimming pool liner
Swimming pool inner liners are manufactured from PVC film.
In general, swimming pool liners are somewhat smaller than the dimensions of the pool. This is necessary to
achieve a wrinkle-free fit. Should the lining be somewhat taut after installation, this will have no affect on its
durability. The liner will give when filled with water, as it is able to stretch by around 20%.
The PVC inner liner of your swimming pool is made from thermoplastic material. You should therefore
ensure that your swimming pool is constructed in outside temperatures of +15°C to +25°C.
Also, do not fit the inner line during blazing sunshine ('blue sky'); wait until evening.
Please note:
1) Shoes with a smooth sole should be worn when installing the inner liner, although socks or bare feet
would be even better. All tools or other sharp objects must be removed from the clothing to avoid the
possibility of damage. Please note that the liner is smooth and there is risk of slipping.
2) Before the inner liner is placed in the pool in the polysack, the base must be free from stones and
any unevenness. These would later lead to damage to the liner during cleaning and can also
adversely affect the appearance. We recommend that protective felt is used to protect the liner.
3) Important: To avoid the formation of red or black algae from the subsoil, which manifests itself in the
form of large dark brown or black areas on the base, we recommend the use of a protective
polyethylene liner as a barrier (not included in the delivery). Should black or brown spots appear on
a pool base which does not have a PE liner after some time, these can be removed with a chlorine
treatment (1 kg 100% dissolved chlorine granulate or the same quantity of dissolved chlorine tablets
or chlorine bleach liquor) with a water level of max. 10 cm within a very brief period.
4) In the factory, all inner liners are first folded once lengthways and then folded once in half and rolled
from the middle out. This means that once unpacked from the polysack (in the pool), the package is
laid at the edge and then rolled into the middle. The second half is then unfolded and pulled to the
opposite end. The liner is then unfolded from the centre and pulled to both sides.
5) The liner wall is then pulled vertically upwards, the upper end laid over the edge of the wooden wall
and fixed in place in the corners with a glue clamp or vice.
6) The corrections to the base and wall which now follow are very important for subsequent wrinkle-free
positioning of the inner liner. The base must be pulled into the grooves so that the external weld
seam which connects the base with the periphery is pushed out as far as possible. It must then be
ensured that the wall liner is pulled vertically and no diagonal or slanted folds are formed. Should this
be the case, the glue clamps or the vice in this area must be removed and the upper edge
repositioned.
Technische Änderungen vorbehalten! Alle Maßangaben sind ca. Maße.
 Copyright HRB 3662
21