Sears Kenmore He2 Plus 110.4751 Serie Manual De Uso Y Cuidado página 11

Lavadora automatica de carga frontal
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

One foot has been installed at a different height on your new
washer. The other three feet were preset at the factory. Properly
leveling your washer will minimize excessive noise and vibration.
1. Push on the upper front panel to be sure that the washer is on
the rear feet. Lower the right front foot until it contacts the
floor. Check the levelness of the washer by placing a level on
the top edge of the washer, first side to side, then front to
back.
1. Check the electrical requirements.
Be sure that you have the
correct electrical supply and the recommended
grounding
method. See "Electrical Requirements."
2. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that the water faucets are on,
6. Check for leaks around faucets and inlet hoses.
2.
3.
If the washer is against a wall, move the washer out slightly
before tipping back. First prop the front with a wood block
and adjust the feet as necessary; then prop the back and
adjust feet as necessary. Repeat this step until washer is
level.
Make sure that all four feet are stable and resting on the floor.
Then check that the appliance is perfectly level (use a level).
After the washer is level, use a 14 mm open-end wrench to
turn the nuts on the feet tightly against the washer cabinet.
IMPORTANT: All four feet must be tightened. If the nuts are
not tight against the washer cabinet, the washer may vibrate,
4. When you are pushing on the edges of the washing machine
top plate, the machine should not move front to back, side to
side, or diagonally,
7.
5. Slide the washer to its final location,
8.
6. Confirm the levelness of the washer,
9.
ElectricaB Shock Hazard
Pmug into a grounded
3 prong outmet,
Do not remove ground
prong,
Do not use an adapter,
Do not use an extension
cord,
Faimure to follow
these instructions
can resumt in death,
fire, or e_ectricam shock,
Plug into a grounded 3 prong outlet.
Read "Washer Use."
To test and to clean your washer, measure 1/2 the detergent
manufacturer's
recommended
amount of HE High Efficiency
detergent for a medium-size
load. Pour the detergent into the
detergent dispenser. Select NORMAL/CASUAL,
and then
select HOLD TO START. Allow the washer to complete
one
whole cycle,
Use only HE High Efficiency detergent.
11

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido