Setup; Attaching The Handle - Cart Model Only; Attaching The Pail Bracket - Cart Model Only; Locking And Unlocking The Gun - KREBS K2015S Manual Del Propietário

0512719A.qrk 21/12/00 1:30 PM Page 5

SETUP

Do not plug in the unit until setup is complete.
Attaching the Handle--Cart Only
1. Position the handle against the cart so that
the holes in the handle line up with the holes
in the cart.
2. Insert the bolts through the holes in the
handle and cart.
3. Tighten the wing nuts onto the bolts.
Attaching the Pail Bracket--
Cart Only
1. Position the pail bracket against the
unit so that the holes in the unit line
up with the holes in the bracket.
2. Insert the bolts through the holes in
the bracket and the unit.
3. Tighten the bolts.
Locking and Unlocking
the Gun
Always lock the trigger off when the gun is not in use.
The gun is secured when the trigger lock is at a 90° angle
(perpendicular) to the trigger in either direction. To unlock the
trigger, turn the trigger lock to be in line with the trigger.
Gun locked
(gun will not spray)
Attaching the Tip to the Gun
POSSIBLE INJECTION HAZARD. Do not spray without the tip
guard in place. Never trigger the gun unless the tip is in
either the spray or the unclog position. Always engage the
gun trigger lock before removing, replacing or cleaning tip.
1. Thread the spray tip onto the
gun. Tighten the nut first
byhand, then tighten more
firmly with a wrench.
© 2000 Krebs - All rights reserved.
WARNING
CAUTION
Gun unocked
(gun will spray)
WARNING
NOTE: When attaching tip to the gun, align the tip
guard as shown in figure below, then
tighten with a wrench.
Begin
tightening
the tip at
this angle

Choosing the Correct Spray Gun Filter

Use the proper gun filter based on the tip size being used.
Part No. Tip Size
0154918 .011
0154675 .013 - .015
0154842 .017 - .023
0154919 .023 and up

Attaching the Paint Hose

1. Be sure that the motor is turned
to OFF (o).
2. Attach the high pressure hose
to the paint hose port. Use a
wrench to tighten the paint hose
securely.
3. Attach the gun to the other end
of the high pressure hose.
Tighten securely with a wrench.
Attaching the Suction Set and Return Hose
1. Attach the suction tube to the inlet valve and tighten firmly
by hand. Be sure that the threads are straight so that the
fitting turns freely.
2. Press the return tube onto the return tube fitting.
3. Place the suction tube and the return tube into the paint.
4. Place the paint bucket onto the floor or hang on the pail
bracket, depending on the model of pump you have.
5
to achieve
the desired
spray angle
when tight.
Filter Mesh Color of Qty.
Type Number Filter
Body
Extrafine 180 mesh red 2 pack
0.084 mm
Fine 100 mesh yellow 2 pack
0.140 mm
Medium 50 mesh white 2 pack
0.315 mm
Coarse 30 mesh green
2 pack
0.560 mm
Return tube
fitting
Inlet valve
Return tube
Suction set
English