Oursson BL0642G Manual De Instrucciones página 11

ELEMENTS OF DESIGN, Fig. B
Measuring cup
Lid
Blender's jar
Blades
Coupling
Motor unit
Rotary switch with buttons
Mill
UTILIZATION, Fig. C
Control panel
Rotary knob – use for following functions:
* Switching the device ON/OFF
* сhanging the speed level from 1 up to 7, where 1 –
minimal speed, and 7 – maximal.
– use this button to turn on turbo mode
– use this button to turn on smoothies mode
– use this button for ice crushing
– ON indicator

– OFF indicator

Before first use, make one preparation cycle
without ingredients, add water into the glass jar.
After that, wipe the body of the device with a dry
soft cloth. Wash the jar, lid, mill, stainless steel
blades with warm water with detergents.
Before assembling and disassembling the de-
vice, make sure it is unplugged.
The blades are very sharp, be careful.
Utilizing the jar:
1. Place the jar onto the motor unit according to the
manual.
2. Add ingredients. Do not fill the jar above the
max. mark.
3. Plug in the device.
4. Select the required speed, using the knob, from
1 to 7, turning it clockwise. The Mix/Grid process
will start automatically.
GRINDING RECOMMENDATIONS
Before grinding, it is recommended to chop ingredients on 2×2×2 cm pieces. Max amount of ingredients is
shown in the table. Follow the recommendations in the recipe book.
Operation
Smoothies and milk-
1500 ml
shakes
Puree from fresh
fruit, berries and 1500 ml
vegetables
Puree from cooked
fruits, vegetables and 750 ml
soups
5. You may also turn on the blender by holding the
button
at maximum speed all the time. The speed won't
change even if you will change the switch's posi-
tion. To turn off the device, release the button.
6. To prepare smoothie press
press the button again.
7. For ice crushing, press
it again.
NOTE: To get ice crumb, select the maximum
speed level, or hold
the pieces are still big, repeat the operation.
8. To finish working with blender, turn the knob to
position. Unplug the device.
9. After that you can disassemble the device.
You can open the lid only when the jar is
removed.
Utilizing the mill:
1. The mill is design to grind coffee beans, rice,
wheat, peeled nuts, pepper, sesame seeds, dried
beans, hard cheese, and breadcrumbs.
NOTE: Always grind cloves, star anise and aniseed
together with other ingredients.
2. Open the mill and put necessary ingredients.
Close the jar.
3. Place the mill onto the electric motor as shown on
the picture.
4. Plug in the device.
5. Turn on the blender, hold the fast mix button
To turn of the device relies the button.
— 60 sec. To turn of the device press
30-45
— MAX (5-7)
sec.
30-45
— MAX(5-7)
sec.
. In this case, the device will be working
button. To stop,
button. To stop, press
button for a few seconds. If
Before placing the jar, make sure that the
knob is in the position.
The mill is not designed to grind very hard in-
gredients like nutmeg or ice cubes. Do not fill
the mill's cup higher that the max mark.
Maximum time of continues use of the blender
is 2 minutes, after that you need to turn off the
device for 3 minutes.
Note
The ingredients must be soft or juicy (ba-
nanas, strawberries, cucumbers, etc.)
Do not puree ingredients with a temperature
higher than 95 C
o
.
button again.
11