Melchioni Family WALLY Manual De Usuario página 11

WARNING: This heater is not equipped with a device to control the room temperature. Do not use this heater in
small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant
supervision is provided.
FEATURES:
1. High quality plastic shell and long using life.
2. PTC ceramic heater elements, high efficiency heating, quickly heating, noiseless, odor-free, non-polluting, no
flame and will not killing the oxygen.
3. Two level heat setting, you can arrange the temperature as your preference.
4. There is temperature fuse for fear of overheating and motor overheat protection. Automatically turn off when
the wind outlet is blocked and turn on again when the sundries are cleared away.
5. Natural/hot wind for selection. You could close the heat element in summer; the heater could blow cool wind.
6. Safety thermostat. Overheat protection.
INSTALLATION
Drill two holes in wall and have a distance of above 2.0m from the ground, the diameter of the hole just contained
the expansion bolt, which the diameter is 6mm. After tucked the expansion bolt, fixed pothook on the expansion bolt
with screw. Make sure pothook should be inserted the bottom. See the drawing as following for a better
understanding. (see the picture)
Use the machine's components (screws and expansion pipe) fix on the wall as following figure, then mounted the
machine.
USAGE
1. Please make sure the capacity should be AC220-240V, 50/60Hz.
2. Put the plug in the wall socket.
1、The distance between the product and the ceiling(and the side)
should be ≥30cm.
2、Product installation size see Figure.
3、Note: when the product is installed, The hook (screw) is aligned
with the hole "A" on the product. After hanging, must be moved to
the "B", in order to firmly fix.
When to remove the product, must be moved from "B" to "A" then
take out.