Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical Shock Or PersonalInjury
Hazard
Disconnectelectricalsupply before
servicing or cleaningthe unit.
Failure to do so could result In elec-
trical shock or personalinjury from
cleanersuddenly starting.
TO CHECK BRUSH:
Base Support Bars
When brushes
are worn to the
level of the base
support bars,
replace the
brushes.
TO REPLACE BRUSH:
1. Remove POWER-MATE:"
cover, belt and
brush assembly. See 'q-o remove belt" in
BELT CHANGING
AND BRUSH
CLEANING.
2. Remove brush supports, washers,
screws, end brush, brush sprocket pieces
from ends of brush assembly.
3. Push out worn
brushes. If the
beater bar is
chipped or
gouged,
replace it.
4. Slide new
beater bar and
brushes into slots.
NOTE: New
brushes and
beater bar may
be easier to install
if they are soaked
in warm water for
a few minutes.
Dry thoroughly
before installing.
5. Reassemble
brush assembly. To line up
screw holes in dowel, sprocket and end
brush, be sure beater bar portion of end
brush lines up with beater bar on brush
dowel.
6. Replace belt, brush assembly,
POWER-
MATE
TM
cover, light bulb and light cover. See
"To replace belt" in BELT CHANGING
AND
BRUSH CLEANING.
Washer
Brush
Support
Brushes
Beater Bar
Brush Dowel
Brush
Sprocket
Flange
Brush
Sprocket
End
Brush
Brush
Support
Screw
Screw
Washer
16
Publicidad
