ACME FlyCamOne FCOIII Manual De Uso página 4

Content FCOΞ Transmitter Set
• FCOΞ Transmitter module (TX)
• FCOΞ Receiver module (RX)
Thank you for purchasing the FCOIII. Enjoy the countless features of the camera.
Find most answers for support a tour Homepage: www.FlyCamOne.com
Preparation
Use the Camera as before. Check the micro switches
at RX and TX – both need to have same
configuration. 4 transmission channels (1-4) can be
selected by position "on". Exchange the screen
module against the TX module and fix the screen
onto the RX module. Switch on all units: Camera, TX
and RX. The video signal will reach a range of 300 m
without obstacles. Any interference that will affect the transmitted signal will not be
seen once stored on the SD card.
Audio
To transmit the Audio signal as well press
volume paddle to adjust the sound.
AV-Out
Use a 3,5mm three conductor plug at the RX and Scart or RCA at TV-side.
Remove the Screen module from the RX while using TV-Out to save power.
Cover the contacts by the cover plate of the FCOΞ Core Set.
FCOΞ V-eyes
See use there.
Limited warranty of the Lipo battery.
The included Lipo battery's capacity is reduced due every discharge /charging
circle and belongs to the wearing parts. Improper use storage and handling as
well as wearing and consumption is not covered by the warranty.
Charging the FCOIII RX & TX
Once connected to the camera module, the TX will be charged at the same time
as the camera. Use the cam's AC/DC adaptor or the USB cable. Proceed same
way for the RX. Modules will be charged when the LED switches from red to
green.
V.1.01
• Manual
www.FlyCamOne.com
at the camera once. Use the