Overview Of The Components - AEG AR 4030 BT/USB/CR Instrucciones De Servicio

English
48
48
Connection
CAUTION:
• Please use loudspeakers with an impedance of 4 ohm.
• The loudspeaker cables must be unearthed.
Connect the device as shown in the diagram:
Operating Instructions
1. Do not switch on the device if the car interior is extremely
hot, for example after an extended parking in direct
sunlight. Wait until the interior is cooled down after a
short drive.
2. Possible malfunctions during operation can be resolved
by pushing the RESET button. Push the RESET button
with a wire or similar (8) to reset the electronics (RESET).
3. The time displayed in standby mode is set automatically
as soon as you listen to a radio station.
Operation
In the following, the functions of the individual device buttons
are described according to the illustration

"Overview of the Components".

1 MODE (On / Off) – Button
a) Press this button to turn on the unit. The notification
"WELCOME" will appear briefly on the display.
Press and hold the button to switch off the unit. The
notification "GOODBYE" will appear briefly on the
display.
b) Press this button to select the different modes. (Radio,
BT, USB, CARD and AUX IN)
AR4030BT-USB-CR_IM
Connection of an External Amplifier
For connection of an external amplifier, use the audio cinch
outputs LINE OUTPUT on the rear panel of the unit. Refer to
the instruction manual concerning the external amplifier.
NOTE:
The USB and CARD mode can only be selected if
you have connected a corresponding medium.
2 Multicontrol / SEL – Button (Volume / Select)
a) During normal playback mode, the control is used to
control the volume.
Together with the previously pressed control (SEL
button), changes can be made in the menu, e. g. the
sound mode.
b) Press the SEL button shortly to enter the selection
menu. Repeated pressing of the SEL button selects
individual menu entries. You can change the settings
of the individual menu entries by turning the volume
control.
BAS (Bass)
TRE (Treble)
BAL (Balance)
FAD (Fader)
BEEP (Sound heard when a button is pressed)
• BEEP ON: A beep sounds whenever a button is
pressed.
• BEEP OFF: No beep.
05.07.16