Stand-Alone Control; Remote Control - Asystems DMA8825 Manual Del Usuario

DMA8825 / DMA8813 / DMA8425 / DMA8413
ONBOARD CONTROL
DMA8825, DMA8813, DMA8425 and DMA8413 include built-in control software. You can get full control over the DMA
matrix amplifier via the control software by plugging in a standard VGA display and a USB mouse to the ports shown
below.

REMOTE CONTROL

1. RM-2VR REMOTE LEVEL CONTROL
Please connect Asystems' RM-2VR Remote Control to
the REMOTE LEVEL CONTROL connectors of the DMA
matrix amplifier. The channels controlled by the VR is
determined by the wiring of the control. Please note, the
ground for channel 2 is internally wired to channel 1� Only
one grounding pin needs to be connected to the DMA.
DMA8425/DMA8413
In the example found to the right, channels one and two
can be remotely controlled using the RM-2VR.
2. RM-4 REMOTE PRESET RECALL CONTROL
With Asystems' RM-4 Remote Preset Recall connected
to the PRESET connector and some configurations within
the control software, 4 presets can be accessed via
pressing a button. See page 15 for more information on
setting presets�
English
7