Setup; Connection With The Mains - EuroLite DPX-405 DMX Manual Del Usuario

4.2 Overview
Frontpanel
8
1) Mode Button: This button will change the operate mode between DMX and chaser.
2) Menu Button: This button will activate the different functions in DMX and chase modes.
3) Up Button: This button will increase the displayed value in the LCD display.
4) Down Button: This button will decrease the displayed value in the LCD display.
5) Green L.E.D. Indicators: These LEDs will indicate their relevant channel activity.
6) LCD Display: This multifunction display will detail all chasers and programs that pertain to the current
operating mode of the pack.
7) Channel Fuses: Each of the four channels is protected by a 6.3A fuse. These fuses prevent you from
overloading and damaging your pack. Be sure to always replace with the exact same type fuse.
8) Circuit breaker: 16A
Rearpanel
9) Power Output: Four channel output.
10) DMX Input: This connector accepts your DMX input signal.
11) DMX Output: This connector sends your DMX input signal through to the next DMX device.
12) Power Input: The main power input.

5. SETUP

5.1 Installation
Install the device on a plane surface or install it in rack.
Rack-installation: This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the controller into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the controller with four screws M6 in the rack.

5.2 Connection with the mains

Connect the device to the mains with the power-plug.
6
7
13/28
5
2 3 4
9 10
00026136.DOC, Version 1.1
11 12