Intended Use - AEG MC 4458 iP Instrucciones De Servicio

11 function selection button
12 button (on/standby)
13 Control lamp (Operational readiness)
Reverse Side (no picture)
Loudspeaker connections (R/L)
AC Mains connection
FM ANT. throw-out aerial
VIDEO OUT Connection
Remote Control
1 MUTE button
2 Number buttons
3 +10 button
4 ALB+ button (up album)
5 Button (next title / search run forward)
Button (title piece / search run backward)
/ Button (iPod/iPhone Menu navigation)
6 TUNE+ Button (Radio search run upward)
7 button (Play/Pause)
8 SOURCE button (function selection button)
9 STOP/AUTO button
10 RANDOM Button (Shuffle replay)
11 ST/MONO Button
12 MEMORY/VIDEO SELECT button
(memory/Video output)
13 EQ Button (Equalizer)
14 SLEEP button (sleep timer)
15 REPEAT button
16 INTRO Button
17 VOL+/VOL- buttons (volume)
18 TUNE- Button (Radio search backwards)
19 ENTER Button (Confirm)
20 ALB- button (down album/radio stations)
21 PROG/MENU Button (Memory / iPod/iPhone Menu)
22 STANDBY button (on/standby)

Intended Use

This device is used for
• The reception of radio programmes
• Playing back audio/MP3 CDs
• Sound reproduction of external audio sources.
It is intended exclusively for this purpose and may only be
used as such.
It may only be used in the manner described in these instruc-
tions for use. The device must not be used for commercial
purposes.
Any other use of this device is considered to be contrary to
the intended use and may result in damage to materials or
even personal injury.
The firm ETV – Elektro-Technische Vertriebsgesellschaft mbH
does not accept any liability for damage caused as a result of
the use of this device contrary to its intended use.
Start-up of the device/Introduction
• Read the operating instructions thoroughly before the
start-up!
• Select a suitable location for the device and for the loud-
speakers. A dry, flat, non-slip surface on which the device
can be easily operated.
• Make sure that the device is adequately ventilated!
• Connect the speakers on the back to the terminals
"R and L" .
• Remove the protective film from the display if it is still
present.
Power Supply
• Insert the plug into a properly installed power socket.
• Please ensure that the mains voltage corresponds to the
information on the type plate.
Batteries of remote control (Batteries not included)
• Open the cover of the battery compartment on the rear
side of the remote control.
• Insert 2 x R03 "AAA" 1.5 V batteries. Please observe cor-
rect polarity (see bottom of battery compartment)!
• If you do not use the remote control for a longer period
of time, please remove the batteries in order to avoid
"leakage" of battery acid.
CAUTION:
• Different battery types or new and used batteries must
not be used together.
• Do not dispose of batteries with your household trash.
Please hand over at authorized collection points or
return to your dealer.
WARNING:
Do not expose batteries to heat or direct sunlight. Never
throw batteries into fire. Danger of explosion!
Setting the Time (in standby)
• Hold down the MEMORY/VIDEO SELECT button (12 on
the remote control) for ca. 2 seconds. The hour display
will start to blink.
• Set the hours with the / button (5 on the remote
control).
• Push the MEMORY/VIDEO SELECT button to save the
entry. The minute display will start to blink.
• Set the minutes with the / button.
• Confirm your entry again with the MEMORY/VIDEO
SELECT button. The time of day is saved.
NOTE:
Storage/display of the time is lost as soon as the electricity
supply is interrupted.
English
37