AEG MC 4464 Instrucciones De Servicio página 32

English
32
15 headphone jack
16 AUX jack
Back
Dipole antenna
Battery compartment (power reserve)
Suspension eyes for wall mounting
Power adapter socket (DC 6 V
First Use of the Device/Introduction
• Select a proper place for the device. A dry, level and slip
proof surface is suitable.
• Make sure the device is vented sufficiently!
• Remove the protective film from the device, if present.
Mounting the stand
If you do not want to mount the device to the wall, place the
device onto the supplied stand.
Wall mounting (Mounting material not included)
You can also mount the device to the wall.
CAUTION:
Make sure beforehand whether there are cables in the wall
which could be damaged!
NOTE: Check the reach of the cable!
To mount the device, make sure that an easily accessible
plug outlet is available within reach of the power cable.
The distance between the mountings for wall mounting is
120 mm.
1. Drill two holes horizontally at that distance.
2. Fit dowels and screws into the holes.
3. Hang the device onto the screws. Check that it is secure.
Power supply
• Make sure the grid voltage corresponds to the figures on
the rating plate.
• Plug the power supply unit into a properly installed
protective contact socket.
• Connect the device with the power supply unit by plug-
ging the jack of the power supply unit into the "DC 6 V
" jack. The DC socket is located near the fixture
for installing the stand (see figure 2 on page 3).
CAUTION:
• This device should only be used with the mains supply
unit (included). Do not use it for other devices.
• Only use a 6 V power supply unit (
supply unit may damage the device.
NOTE:
• Disconnect from mains power supply during longer
periods of non-use.
• If you have not inserted any backup batteries, the
storage of the time and the radio station will be lost as
soon as the power supply has been interrupted.
)
Inserting the backup battery
(Batteries not included)
If there should be a power outage or if the mains plug were
to be disconnected from the electrical outlet, then the set-
tings will be maintained with inserted backup batteries.
1. Open the battery compartment on the back.
2. Insert 2 batteries of the type AAA/R03 1.5 V into the bat-
tery compartment. Ensure the correct polarity (see battery
compartment).
3. Close the battery compartment again.
CAUTION:
• Do not expose the batteries to high temperatures or di-
rect sunlight. Never throw batteries into the fire. There
is a danger of explosion!
• Batteries may leak and lose battery acid. If the device is
out of use for long periods, remove the battery.
• Non-rechargeable batteries may not be charged.
• Chargeable batteries may only be charged under adult
supervision.
• Chargeable batteries must be removed from the toy
before they are charged.
• Different battery types or new and used batteries must
not be used together.
• Batteries must be inserted with the correct polarity.
• Spent batteries must be removed from the toy.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer' s .
• The terminals may not be short-circuited.
Setting the time
1. Switch the device to standby with the STANDBY button.
2. Keep the PROG/TIME SET button (13) pressed for about
2 seconds. The time starts flashing in the display.
3. Use the
ton (3) to adjust the minutes.
4. Press the PROG/TIME SET button again to store the
time.
NOTE:
If you do not press any button within 4 seconds, all settings
). A different
will be saved automatically.
button (14) to adjust the hours and the but-