Cleaning, Maintenance And Ordering Of Spare Parts; Replacing The Power Cable - Hercules H-FS 921 Manual De Instrucciones

7. Operation
7.1 Even cutting (Fig. 1/16)
•
Set the cutting width with the parallel stop (2)
and lock in position with the thumb screws
(10). The width of the workpiece can be read
on the scale.
•
Fig. 16 shows the correct position for your
hands during even cutting. The rate of advan-
ce must not exceed the cutting capacity of the
wheel. This is to make sure that no material
comes off, as this may cause accidents or
injuries.
Notice! Keep a constant check on the water
level
7.2 Making 45° miter cuts (jolly cuts)
(Fig. 17)
•
Position the table as shown in Fig. 17 and
lock in position with the handles (7). Position
the tile with the glazed side on the work sur-
face and make sure that the diamond wheel
does not touch the glaze on the tile. Correct
the cutting guiding position if necessary.
•
Fig. 17 shows the correct position for your
hands during miter cutting to 45°. The right
hand holds the workpiece in contact with the
diamond wheel while the left hand pushes the
workpiece forward. The rate of advance must
not exceed the cutting capacity of the wheel.
This is to make sure that no material comes
off, as this may cause accidents or injuries.
7.3 On/Off switch (Fig. 1)
•
To switch on, press the „I" on the On/Off
switch (12).
•
To switch off, press the „0" on the On/Off
switch (12).

8. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Anl_H_FS_921_Teil1_SPK7.indb 19 Anl_H_FS_921_Teil1_SPK7.indb 19
GB
9. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
9.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
9.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
9.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
- 19 -
18.09.2015 09:26:13 18.09.2015 09:26:13