MAFA TMK 450 Manual De Instrucciones página 11

User Manual English
Simple, reliable handling of the device is done by pressing the lever in two stages:
1 Level: blow air
By lightly pressing the lever 050211 (No. 13) to the first pressure point blow air is released.
Use:
Cleaning of tools
Removing tinder and other casting residues
Distributing the separation material and blow-dryin
2 Level: Medium-air mixture
When fully pressed the lever immediately, atomizing / misting of the air-liquid mixture is effected.
Performance: Suction: at 4 bar = approx 1.1 liters / min.
Blowing air (after air) atomizes the last spray media. Thus, the nozzle is kept clean and no liquid can
drop from the gun.
Spray air pressure: Set spray air pressure with a reducing valve.
Using a pressure pot you need a discharge pressure of 0,6 bar.
The delivery pressure of the atomizing air determines the droplet size of the spray.
3.2 Operating instructions
It must be taken to use only clean air. Similarly, the spray material should be without pollution and
be mixed as specified by the material manufacturer.
4 Service
4.1 Care
IMPORTANT!
After completion of spraying, the spray gun should be
sprayed through shortly - 1 Level: spray air. This ensures
that no rest of liquid remains in the tube.
CAUTION!
The spray does not point at anyone. The spraying may be
accompanied, depending on spray air and media delivery
pressure of a loud noise. For safety reasons, it is advised
to wear both eye protection and ear protection.
WARNING!
Danger from inflammable and hazardous to health
sprayed material. The safety notes on the storage
container for spraying material or material safety data
sheet must be observed.
page 11 from 60