Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS MANUAL
Digital light meter
C-LOGIC 250
Code: 301000014
ENGLISH
C-LOGIC 250 is a multi-functional light meter that has an easy-to-use interface and can be
easily used with one hand. This light meter is able to measure the visible light produced by
fluorescent lamps, metal-halide lamps, high voltage sodium lamps, electric incandescent
lamps and a variety of lighting sources.
SAFETY INFORMATION
Warning
Do not use the light meter in an environment with dust or flammable gasses.
Warning
User should observe the following notices to guarantee safe operation and obtain
optimum performance.
Upon reception of the light meter and before initial use, inspect it to ensure no damage was
caused during shipping. Check all accessories and make sure all buttons function properly.
If the user find obvious damage or malfunction in operation, please contact the supplier.
USE
• The operation temperature range for the light meter is -10 and +50ºC (14-122°F).
• In order to avoid damage, especially falling accidents, handling and use should be avoided
during severe mechanical vibration.
• The light meter should only be calibrated and repaired by trained personnel.
• Before each use, check the opto-sensor of the light meter for damage and dust. Make sure
the meter is in good, smooth and clean conditions. If one or more functions of the light meter
function irregularly or do not operate, avoid using the meter.
• During operation of the light meter, do not allow the measurement value to stay at 0L for
an extend period of time.
• Keep the meter out of direct sunlight to guarantee its normal operation and long-term
service life.
• If the meter is subject to an intensive electromagnetic field, its ability to function properly
will be affected.
• Only use the batteries specified in the technical data section.
• Avoid exposing the batteries to damp environments. If the low battery symbol appears on
the display, the user should replace batteries immediately.
MAINTENANCE
If potential failures are noticed during operation, use the following steps to check for a
possible problem:
• Check batteries. If
appears on the LCD display, batteries should be replaced.
• Refer to the operation instructions to check if operation steps are followed correctly.
• Repair on the meter should be performed by service centers or other qualified personnel
only.
CLEANING
First wipe the meter with a damp soft cloth with clean water or neutral detergent and then
with a dry cloth.
• Make sure the lux meter is off before cleaning.
• Do not use benzene, alcohol, acetone, ethyl ether, ketones, solvents, gasoline, etc. to
clean, since the lux meter could be altered.
• After cleaning, the lux meter can only be reused once it is completely dry.
BATTERY REPLACEMENT
If the low battery symbol appears on the screen, the battery must be replaced.
Follow the next steps in order to replace the battery:
• Turn off the meter
• Remove the screw on the battery cover and open the battery compartment
• Remove used batteries
• Replace with new batteries observing polarity
• Replace the battery cover and tighten the screw.
Warning
Pay attention to the correct polarity of battery when putting in or replacing batteries. In
case of polarity reversal, the light meter can be damaged and can even cause explosion
or fire.
Do not connect the two polarities of the battery together or throw battery in fire. This may
cause the battery to explode.
Do not attempt to take apart the battery. The battery's alkaline electrolyte is highly
corrosive. In case of electrolyte contact with skin or clothes, immediately rinse touched
parts with clean water. In case of contact with eyes, immediately rinse eyes with clean
water and seek medical advice.
• The light meter should be turned off before replacing batteries.
• Use batteries specified in technical data only.
•
lf the meter is not to be used for a long time, take out the batteries. In case the meter is
EN
polluted due to battery leak, the meter should be sent to the manufacturer for cleaning and
maintenance.
• For disposal of used batteries, follow existing specifications on battery recycling, reuse and
treatment.
ACCESSORIES
• Short manual
• 9V 6F22 battery
FULL MANUAL DOWNLOAD
1 pc
1 pc
You can download the complete
manual at the URL
http://www.c-logic.es/manuales
MANUFACTURER:
MGL EUMAN S.L.
Parque Empresarial de Argame,
C/ Picu Castiellu, Parcelas i-1 a i-4
E-33163 Argame, Morcin
Asturias, España (Spain)
Publicidad
