Unpacking The Device; Overview Of The Components; Function Of Switches; Application Notes - Profi Cook PC-VK 1134 Instrucciones De Servicio

Unpacking the Device

1. Remove the device from its packaging.
2. Remove all packaging material, such as film, filler,
cord holder and carton packaging.
3. Check the content for completeness.
NOTE:
The device may still contain dust or particles gen-
erated during production. We recommend that you
clean the device as described under "Cleaning".

Overview of the Components

1 TURBO button
2 NORMAL button
3 DRY button
4 MOIST button
5 VAC SEAL button
6 SEAL button
7 STOP button
8 Welding wire
9 Roll foil tray
10 Release
11 Vacuum chamber
12 Sealing
13 Air intake
14 Cutting knife

Function of Switches

NORMAL / TURBO
Choose between the functions NORMAL and TURBO.
The control light indicates the selected function.
• The function NORMAL is suitable for soft, pressure
sensitive goods.
• To increase the power of the vacuum pump, select
the TURBO function.
DRY / MOIST
Choose between the functions MOIST and DRY. For
example, choose MOIST for meat that contains a lot of
meat juice and choose DRY for a peeled apple.
The control light indicates the selected function.
VAC SEAL
Vacuuming and heat sealing are performed in one

operation.

SEAL
The foil is only heat sealed.
• Use this function with liquids if you want to heat seal
42
PC-VK1134_Instruction Manual_new2
without vacuum.
• Press the button, to prematurely abort a pumping
operation, triggered by the VAC SEAL function to be
able to heat seal straight away.
STOP
Press the button to cancel the entire operation.

Application Notes

Location
Place the device on a non-slip, flat surface. Make sure
that the ventilation slots at the bottom of the device are
not concealed.
Power Cord
Completely unwind the power cord from the back.
Insert the cable into the cable guide so that the device
cannot tilt.
Electrical Connection
1. Check whether the device is suitable for the exist-
ing mains voltage. The relevant information can be
found on the type plate.
2. Connect the power cord to a properly installed
earthing contact outlet.
NOTE:
Operate the device with dry hands only, to prevent
the electronic touch panel from failing.
Operation
Create a Bag From Yard Goods of the Roll.
Foil can also be purchased as yard goods.
NOTE:
The foil should have a special structure so that the
air can be extracted well! You can use rib, honey-
comb or rhombic structure foil.
To make a bag from yard goods, please follow the
steps below:
1. Open the device by pressing the release buttons
(10) on the left as well as the right side.
2. Place the roll in the designated tray (9).
3. Measure the desired length of the foil.
4. Use the cutting knife (14) to separate the foil with a
straight cut.
5. Place the wrap foil on the front sealing (12). Press
down the cover evenly and firmly, until it snaps into
place on both sides with an audible click.
19.06.18