Joneca ASD-1250 Manual De Instrucciones página 3

3. INSTALLATION OF MOUNTING ASSEMBLY
A
STOPPER
B
REMOVABLE SPLASH GUARD
SINK FLANGE
C
D
FIBER GASKET
SUPPORT FLANGE
E
F
UPPER MOUNT RING
G
MOUNT SCREWS
H
RETAINER RING
CUSHION RING*
I
J
LOWER MOUNT RING*
K
SILVER GUARD® (Included in White Carton)
NOTE: As the mounting assembly is properly assembled at the factory, please pay close
attention to the order of the mounting system parts.
a. The Cushion Ring and the Lower Mount Ring will remain attached to the disposer
during installation. Take apart the other parts of the mounting assembly by rotating Lower Mount
Ring (J) clockwise until the Lower Mount Ring Tabs slide off from the Upper Mount Ring ramp. This
allows you to pull the Sink Flange up and out of the remaining Lower Mount Assembly. Note the order
of these parts as they are arranged in the required order. Unscrew the 3 Mount Screws until the Upper
Mount Ring can be moved to the top of the Support Flange. Remove the Retainer Ring with a screw
driver.
b. Keep the remaining parts placed together in the order they were removed. Before you connect the
disposer to the mount assembly under the sink, make sure the Lower Mount Ring is in place and the
black Cushion Ring is still engaged properly to the top of the hopper.
READ CAREFULLY AND COMPLETELY BEFORE STARTING
MOUNT TAB
DISPOSER
NOTE: Cushion Ring included between the Upper
Mount Ring and Lower Mounting Ring.
* Part not disengaged during disposer installation.
3
LOWER MOUNT RING
DISHWASHER INLET
CUSHION RING