Instructions Of Use - Kangaroo Kn-18GH Manual De Instrucciones

1B
OPERATION
1.7

Instructions of use

a) – POWER ON
1.- Turn the engine switch to "ON".
3.- Push the choke valve lever to "ON".
4.- Push the throttle lever one or two step
5.- Pull the handle until feeling resistant,
Pull the rope handle slightly and then jerk immediately when you feel resistant.
Hold the handle and let it go step by step with the rope bouncing back.
6.- Warnings for operating rammers at high altitudes.
When using standards oil machines, the air with low oxygen content will make the
concentration of oil in the oil-gas mixtures too high, which will result in the reduced level of
efficiency of engine and the increase of the consume of oil. Therefore, it is necessary to
change the nozzle of the carburetor with a smaller aperture and readjust the idle speed of
the carburetor in order to improve the performance of the engine. But under the condition
that the nozzle of the carburetor is fitted, the power of the engine will still reduce about
3.5% with each 300 meters raise of the sea level.
b) - USING THE RAMMER
1.- Open the choke on the carburetor after Start, warm up for about 5 min.
2.- Pull the accelerator control handle to the the backmost end.
3.- Guide rammer with its handle.
4.- To stop the rammer put the switch to "OFF" position.
1B-6
2.- Screw the fuel valve to "ON".
rightward.
then pull the rope and Start the engine.
ATENTION
ATENCIÓN
ENGLISH