Overview; Initial Operation - Metabo ASR 35 AutoClean Instrucciones De Manejo

ENGLISH
ENG
Always clean and disinfect the vacuum cleaner
immediately after use.
Never open the appliance outdoors during rain or
storms.
The appliance must not be operated in areas with
an explosion hazard.
Ensure that the vacuum cleaner is steady.
If the extracted air is discharged into the room,
ensure there is an adequate air change rate (L) in
the room. Observe the regulations that apply in
your country.
Caution! This appliance contains dust that
is harmful to health. Discharge and mainte-
nance operations (including disposal of the
dust collection containers) must only be carried
out by qualified specialists wearing appropriate
protective clothing and equipment.
Warning - general danger!
Caution! Do not use the appliance until you
have read the Operating Instructions.
WARNING - Operating staff must be provided with
appropriate instruction on how to use this vacuum
cleaner.
While the appliance is suitable for extracting
substances that pose a slight threat to health, it is
not appropriate for reducing wood dust in inhaled
air.
Dust from material such as paint containing lead,
some wood species, minerals and metal may be
harmful. Contact with or inhalation of the dust may
cause allergic reactions and/or respiratory
diseases to the operator or bystanders.
Certain kinds of dust are classified as carcinogenic
such as oak and beech dust especially in conjunc-
tion with additives for wood conditioning (chro-
mate, wood preservative).
Observe the applicable regulations in your country
for the filter cartridges. The filter cartridges (made
of polyester) that are contained in the delivery
comply with dust class M (filters trap 99.9 % of all
dusts as of Ø 3 µm). HEPA filter cartridges see
chapter11 Accessories.
The total maximum permissible current
consumption (of dust extractor and connected
unit) must not exceed the value I
page 2). You can reduce the current consump-
tion of the vacuum cleaner with the "Current
Control" feature, and thus adapt it to the on-
site conditions. See chapter 6.3. If the current
consumption is too high, the vacuum cleaner or
the wiring can overheat and cause a fire.
8
-----------------------------------------------------
SYMBOLS ON THE TOOL:
V .................. volts
A .................. amperes
Hz ................ hertz
W ................. watts
~
.................. alternating current

4 Overview

See page 3.
1 Current Control dial
2 Rotary switch On/Off/Automatic/AutoClean
3 Volume flow control display
4 Plug socket for power tool
5 PE filter bag *
6 Fleece filter bag *
7 Paper filter bag *
8 Upper part
9 Snap lock
10 Container
11 Cable holder (fold it back and use it to
12 Suction opening
13 Locking bar (for opening the hood to change
14 Locking knob
15 Motor protection filter
16 Filter cassette (according to IFA C)
* depending on equipment/not included in scope
of delivery

5 Initial Operation

stated on the rating label, match with your
power supply.
5.1
Paper filter bags (7) are not suitable for wet vacu-
uming.
(see table,
max
Switch off the appliance, remove the mains plug
and open the snap locks (9). Remove the upper
part of the appliance (8) from the container (10).
paper
suspend the mains connection lead)
filter cassettes)
Before plugging in, check that the rated
mains voltage and mains frequency, as
Inserting a Paper Filter Bag or Fleece
Filter Bag
On the inside of
the suction
opening, push the
red rotary slide
with its "triangle"
marking upwards.