Typical Installation - Powermate Px P024-0293SP Manual De Instrucciones

RISK OF BURSTING AND/OR INJURY. Never connect to an air source that is greater
than 90 psi. Over pressurizing the tool is able to result in bursting, abnormal operation, break-
age of the tool, or serious injury to persons. Use only clean, dry, regulated compressed air
at the rated pressure or within the rated pressure range as marked on the tool. Always verify
prior to using the tool that the air source has been adjusted to the rated air pressure or within
the rated air pressure range.
RISK OF EXPLOSION AND INJURY. Never use oxygen, carbon dioxide, combustible
gases or any bottled gas as an air source for the tool. Such gases are capable of explo-
sion and serious injury to persons.
Key Description
A Air hose
B In-line Filter
C Tee Fitting
To begin using the tool:
1. As a standard practice, drain water from the air
compressor tank
(reference your compressor operators manual for
detailed instructions).
2. Install a 1/4" NPT male connector into the air inlet port
on the tool (see Figure 2). Note: Use Teflon® Tape on
all threaded connections.
3. Turn on the air compressor and allow it to build up
pressure.
4. Adjust the air compressor's regulator or the supply line
regulator to 90 PSI.
5. Assemble the selected chisel to the air hammer (see
Figure 3);
a. Insert the selected chisel into the quick-change
chisel retainer (see A).
b. Pull back the quick-change chisel retainer and
push in the chisel (see B).
c. Release the retainer to lock the chisel into place
(see C). Note: the chisels are normal wear items
and should be replaced when worn.
If the chisel is not securely held in place by the quick-change chisel retainer, the chisel
may come loose and cause severe personal injury.
6. Connect the tool to the air hose quick coupler. NOTE: It is recommended that a whip hose with a swivel
(not included) be used to prevent twisting, kinking and excessive wear to the air hose (ref. item "F"
in figure 1 for recommended connections).

TYPICAL INSTALLATION

Key Description
D In-line Oiler
E Air Hose
F Whip Hose
OPERATING INSTRUCTIONS
and air lines prior to use each day
AIR SOURCE SAFETY
Key
G Quick Coupler
H Male Connector
I Air Tool
Figure 2
Figure 3
4 - ENG
Description Key
J
K
Figure 1
Description
Female Connector
Spray Gun