Surface Mounting - Gama Sonic GS-36 Manual De Instrucciones

Assembly Instructions

Surface Mounting

1. Fix the base (E) to solid, flat surface using the screws
provided.
2. Assemble the mounting poles (B, C and D) into the
Base (E); Rotate to the right so that the plastic
notches slide under the ledges. Gently tighten the
screws provided (1 screw to each part as shown in
figure 1).
Note: there are 3 optional heights to use for your
convenience, (as shown in figure 1).
3. Slide the lamp unit (A) into the upper part of the
mounting pole (B). Carefully rotate to the right so that
the plastic notches slide under the ledges. Gently
tighten the screw provided.
Ground Mounting
1. Assemble the mounting poles (B, C and D) and stake
(F); carefully rotate to the right so that the plastic
notches slide under the ledges. Twist until secure
(screws provided for assembly parts B, C and D).
Note: there are 3 optional heights to use for your
convenience (as shown in figure 2).
2. Carefully insert the stakes into the ground where
desired.
NOTE: If the ground is hard and packed, moisten the
ground with water before inserting the stake (to avoid
breakage). Use a rubber mallet (not included), if
necessary, to gently tap stake into ground.
3. Slide the lamp unit (A) into the upper part of the
mounting pole (B). Carefully rotate to the right so that
the plastic notches slide under the ledges. Twist until
secure (screw provided for assembly parts A and B).
Figure 1
Figure 2
3