Cycles, Options A Ndlights - Maytag MDB-7 Guía De Uso Y Cuidado

Cycles, Options a ndLights
Cycles
Choose the cycle that best describes your dishload by pressing the cycle select pad. (See page 3, Operating
Tips, for how to begin the cycle).
Heavy Wash Long cycle for heavy food soils. 132" 2 washes/3 rinses
Medium cycle for average food
Normal Wash soils. The turbidity sensor is 97-117" 1-2 washes**/1-2 rinses**
active with this cycle.
Light Wash Short cycle for light food soils. 82* 1 wash/2 rinses
Rinse Only Rinses dishes being held until 9 1 rinse
(select models) there is a full load.
Includes approximately 30 minutes of dry time.
**Number of fills will vary depending on the soil level of each load.
Notes:
• Depending on water temperature, there may be time added to the cycle to bring water up to temperature.
• Only the following certified cycles have been designed to meet NSF requirements (NSF/ANSI 184 Residential
Dishwasher) for sanitization: Heavy Wash, Normal Wash and Light Wash.
Cycle Options
In addition to choosing a cycle, choose as many available options as are needed for your dishload.
Sanitizes dishware. When the cycle monitor recognizes that the proper Heavy Wash*
Sanitize conditions have been met, SANITIZED light will activate at the end of the cycle. Normal Wash*
[select models) Sanitization may not be achieved if there is an interruption of the cycle, Light Wash*
power failure or if the incoming water temperature is below 120° F (49° C).
Extra Rinse Adds an additional rinse to cycle. An extra rinse helps to improve results All cycles
[select models) in hard water situations. (except Rinse Only
[select models[)
Heated Dry
For enhanced drying results, select this option. When Heated Dry is not
selected, towel drying of some items such as plastic and items with non-stick
surfaces may be necessary and more moisture may be noticed adhering
to the dishwasher interior. In models with plastic interiors, it is normal to
notice vapor escaping from the door vent as the heat dries your dishes.
Vapor will escape even if Heated Dry is not selected.
All cycles
(except Rinse Only
[select models])
* Only these cycles have been designated to meet NSF requirements (NSF/ANSI 184 Residential Dishwasher) for sanitization.
Options
Starts and stops dishwasher. See page 3 under Operating Tips: All Cycles
START/Cancel Operating the Dishwasher, for explanation.
Used to automatically start the cycle at a later time. See page 7 All Cycles
Delay for instructions.
6