Transcend Heated Humidifier Guia De Inicio Rapido página 5

2. Place the PAP device into the
corresponding slots at the top of the
Humidifier and slide the PAP device
forward until the nose cone is inside the
humidifier body (Image f).
3. To power the Humidifier, plug the power
supply cord into the back of the device,
then connect the power supply to a wall
outlet. The leftmost LED will turn solid
green indicating power to the Humidifier
(Image g)*
4. Separately power the PAP device as
described in its User Manual. The PAP
device may be powered via wall (main)
power, Transcend battery, or Transcend
Mobile Power Adaptor.
5. Start therapy by pressing the Power button
on the PAP device. Air flow from the PAP
device will automatically turn on the
Humidifier.
6. The Humidifier will begin warming
automatically. The middle green LED will
turn on indicating that the Humidifier is warming. It will take approximately 60 minutes
for the Humidifier to reach its maximum heating temperature (Image h).
Note:
If a fault has occurred with the Humidifier, all three LEDs will begin to flash. Please
refer to the Transcend Heated Humidifier User Manual for more information.
Note:
W hen the reservoir is empty or has been detached from the Humidifier, the third LED
will turn red.
7. Adjust the heat setting of the Humidifier by using the Settings Knob located on the back
of the Humidifier. If a heat setting has been recommended by your healthcare provider,
begin at that setting and adjust the dial up or down to reach your desired comfort level
(Image h).
8. T he 0 setting will turn the Humidifier heating function off. If you turn the heat setting to the
0 setting, it must be returned to a higher setting to resume heated humidification.
9. To stop PAP therapy, simply press the Power button on the Transcend PAP device. The
Humidifier will stop automatically.
*The Humidifier may only be powered by the AC power supply.
TRANSCEND HEATED HUMIDIFIER QUICK GUIDE
f
Nose Cone
g
h
• ENGLISH • PAGE 5